13
Charging your E-Bike
Charging your e-bike is a simple process. You require the following:
• The charger that came with your e-bike.
• A 110V household electrical outlet.
Charger Warning
Only use the chargers that were supplied with your e-bike. Using chargers that do not have
specicaons idencal to those which came with the e-bike could irreparably damage
your e-bike’s baery and electrical systems, and may cause injury.
To charge your e-bike, follow these steps:
1. Turn o the e-bike and remove the key from the “ignion.”
2. Plug the female end of the charger cable into the charging slot on the e-bike.
3. Plug the male end of the charger power cable into your wall socket. This should be
a110v household electricity supply. You can also use a portable generator, if necessary,
but make sure it provides 110V current.
4. Allow the e-bike’s baery to charge for the appropriate amount of me
(6-12 hours).
5. Disconnect the charger when the LED light on the charger is green. The baeries
have been fully charged.
If your charger’s LED status light does not change from red to green over an extended
period of me, for perhaps more than 14 hours, and the baery is very hot, the baery
or charger may need replacing. Stop charging and bring both to your Daymak dealer
immediately. Do not charge the baery.
To Next Page
Loading...
Need help?
General