15
Charging the Em4 (direct)
The EM4 comes with two lithium Ion ba ery packs that can be charged together or
individually. These can be done both in and out of the bike. To charge the EM4 directly in
the unit look for the charge port underneath the seat. It will be covered with a ap that
you must li up and then plug the female end into that port.
Once the bike is charging the charger will glow red. When the unit is fully charged the
charger will glow green and then your bike is ready to go.
Warning
Do not leave the EM4 charging for long periods of me a er it is fully charged. Once the
bike is charged unplug it ASAP.
Accessing your Circuit Breaker
To prevent surges, we have installed a circuit breaker.
If you are unable to get power to your bike more
than likely your circuit breaker has been triggered
and needs to be switched to the on posi on.
To do this:
Unlock the glove compartment, and li up the
holding container. (See next page for more info)
To Next Page
Loading...
Need help?
General