26
The Brakes
Front Brakes
The brakes on your e-bike are drum-brakes, like those found on gas scooters and
motorcycles. They generally provide for very ne stopping and control. This is a very tested
and well-designed technology, but even so, the brakes will require servicing from me to
me, and may have to be adjusted for tension.
Unlike normal fric on-grip bicycle brakes, which clamp down from the outside, the drum
brakes clamp from the inside. When the brakes are ac vated, tension increases and the
clamps engage. This is a very e ec ve and reliable way to stop a vehicle.
The brakes are contained within a sealed unit, and are very nely adjusted and ed.
Rear Brakes
The rear brakes on your e-bike are EABS Brakes (Electric Absorp on Braking System).
These provide a good fric on-grip when they are ac vated. They signi cantly less than
standard drum brakes. Using these brakes helps to reduce the weight of the e-bike and
improve its performance.
The Chain and Pedals
The pedals are connected to the rear wheel. Along with the chain, they provide a human-
powered “drive train”. This is an important part of your e-bike. The pedals are not
removable and should not be removed.
VeHICLE IDENTIFICATION NUMBER
(VIN)
Your unit comes with a Vehicle Iden a on
Number. You should write this down and
keep it somewhere safe in case of the of
your unit. This is also required for registering
your warranty on the warranty sec on of
Daymak.com. To nd the VIN on your EM4
look on the right hand side of the steering
column
To Next Page
Loading...
Need help?
General