Need help?Do you have a question about the DaytonAudio SA25 and is the answer not in the manual?
Power Output| rated power output into 8 ohms | 15 watts RMS |
|---|---|
| rated power output into 4 ohms | 25 watts RMS |
Audio Specifications| signal to noise ratio | 90 dB A-weighted |
|---|---|
| input impedance | 10.4K ohms |
| low pass adjustment | 60 Hz – 180 Hz |
Power Requirements| voltage | 120 VAC |
|---|---|
| frequency | 60 Hz |
| power consumption | 48W |
Weight and Dimensions| dimensions | 6-5/16" W x 6-5/16" H x 2-9/16” D |
|---|---|
| enclosure cutout | 5-1/4” x 5-1/4” |
| weight | 2.50 lbs. |
RCA jacks accepting standard line level inputs from a pre-amp source, internally combined into mono.
Speaker level inputs using spring clip jacks for connection with bare wire from a full range amplifier.
Speaker level passthrough outputs using spring clip jacks to pass signal to main L/R speakers.
Hardwired AC power cable with externally-accessible fuse, supplied with USA plug, not suitable for 230V.
Matches amplifier input sensitivity to source output; functions as volume control, turns off at 'clicks'.
Sets subwoofer's highest frequency (60-180 Hz, 24 dB/octave slope) for crossover integration.
Illuminates green when the amplifier is on; check power and gain if not lit.
Rear mounted lead connects amplifier to driver; uses insulated quick disconnects for polarity.
Details rated power, SNR, input impedance, dimensions, power requirements, and weight.
Covers shock hazard, ventilation, heat sources, power cord protection, and cleaning.
Provides details on the 1-year warranty for plate amplifiers and limitations.
To Next Page