Need help?Do you have a question about the DaytonAudio SA1000 and is the answer not in the manual?
Controls amplifier power state. LED indicates standby or active mode.
Adjusts the overall amplifier output level to match system speakers.
Sets the low-pass crossover frequency from 30 Hz to 200 Hz for subwoofer integration.
Compensates phase from 0 to 180 degrees for acoustic summation.
Customizes one band of equalization for tone shaping and room correction.
Connects the amplifier to AC mains power; supports 110V/220V operation.
Activates amplifier from standby via 12V DC signal from automated systems.
Connects amplified signal to subwoofer drivers; accepts bare wire, banana, or spade plugs.
Selects turn-on stimuli: 12V trigger, auto signal sensing, or always on.
Adds +3dB boost at 25Hz to enhance low-end response.
Removes subsonic information below 18Hz to tighten low-end response.
Accepts stereo line-level audio signals; summed to mono.
Loops line-level signal to other audio equipment with a 80Hz high-pass filter.
Illustrates switch settings for Bass Boost and Subsonic Filter combinations.
Details rated power output, signal-to-noise ratio, and efficiency.
Covers input impedance, filter frequencies, and EQ parameters.
Lists dimensions, power voltage, consumption, and weight.
General| Brand | DaytonAudio |
|---|---|
| Model | SA1000 |
| Category | Amplifier |
| Language | English |
To Next Page