Need help?Do you have a question about the DaytonAudio SA100 and is the answer not in the manual?
General| Frequency Response | 20 Hz - 20 kHz |
|---|---|
| Input Impedance | 10 kΩ |
| THD+N | 0.1% |
| Signal to Noise Ratio | 100 dB |
| Weight | 4.4 lbs |
| Power Supply | AC 120V |
| Damping Factor | 100 |
RCA jacks for line-level stereo signals, internally combined to mono for connection to pre-amps.
Speaker level inputs/outputs via binding posts or spring clips for connection with full-range amplifiers.
Details on the AC power cable, fuse, and the output lead for connecting to the subwoofer driver.
Adjusts input sensitivity, sets crossover frequency, and controls phase reversal for system integration.
Manages power modes (On, Off, Auto) and indicates operational status or protection faults.
To Next Page