Need help?Do you have a question about the DaytonAudio DTA-2 and is the answer not in the manual?
General| Brand | DaytonAudio |
|---|---|
| Model | DTA-2 |
| Category | Amplifier |
| Language | English |
Solder speaker wires to points A & B, and power leads to point C, observing polarity marks.
Solder LED at point D or use wires; mount from bottom, anode to left eyelet, cathode to right.
Wrap speaker wires through ferrite cores (one wrap per core) and solder to terminals.
Solder output capacitors in parallel across speaker terminals with speaker wires.
Connect 12VDC, 2000mA supply to leads or jack; connect volume control via ribbon cable.
Reference diagram showing TA-2024 IC, input/output circuits, and capacitors.
Details warranty period, exclusions for misuse, and policies for unassembled kits.
Information for sending products for repair/replacement outside the warranty period.
To Next Page