Need help?Do you have a question about the DaytonAudio DTA30HP and is the answer not in the manual?
Indicates power status and operational readiness.
Controls the unit's power state.
Connects headphones, disabling speaker outputs.
Front input for portable devices, disables rear RCA inputs.
Adjusts the audio output volume level.
Line-level inputs for permanent connection of devices.
Binding posts for connecting speakers.
Specifies power requirements and connection type.
Details on power output, distortion, impedance, and SNR.
Information on headphone output power and impedance.
Includes power, dimensions, and weight.
General| Power Output | 30 W per channel |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Input Impedance | 47k ohms |
| Input Sensitivity | 300 mV |
| Power Supply | 24 VDC, 3A |
| Dimensions | 36mm H x 98mm W x 118mm D |
| Weight | 0.75 lbs. |
| Total Harmonic Distortion | < 0.1% |
| Minimum THD+N | <0.1% |
| Signal-to-Noise Ratio | >95 dB |
| SNR | >95 dB |
| Headphone Output | 3.5mm |
To Next Page