EasyManua.ls Logo

dB Technologies OPERA REEVO 210 - First Power-On; Package Contents; Power Supply Section

dB Technologies OPERA REEVO 210
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English
24
OPERA REEVO
Cod. 420120426 REV. 1.0
POWER SUPPLY SECTION
7. ON/OFF SWITCH
Switch to turn the device ON or OFF..
8. “MAINS INPUT” POWER SUPPLY CONNECTOR
Mains input for VDE connector.
9. FUSE
Protection fuse.
CAUTION!
Only use the power cable provided or other dBTechnologies power cables.
Do not use the monitor for a prolonged period with the limiter LED steadily lit or flashing as
this indicates operation under stress with excessive distortion.
2. FIRST POWER-ON
PACKAGE CONTENTS
On opening the OPERA REEVO speaker package, check that no items are missing. The package contains:
OPERA REEVO speaker
power cable with VDE connector
quick start manual and warranty documentation
transport case
8
9
7
220-240V~ 50-60Hz 1.3A
(T3.15 L 250V~)
FUSE
ON
OFF
POWER
MAINS INPUT
CAUTION
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
ATTENTION
RISQUE DE CHOCH ELECTRIQUE
NE PAS OUVRIR
AEB INDUSTRIALE S.R.L.
Via Brodolini, 8
Località Crespellano
40053 VALSAMOGGIA (BO)
ITALY
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
(REPLACE FUSE WITH SAME RATINGS)
(REMPLACER LE FUSIBLE AVEC LE MÊME TYPE)
Internal voltage setup
110-120V~ 50-60Hz 2.6A
(T6.3A L 250V~)
Serial N.

Table of Contents

Related product manuals