PLAYBACK
After all the connections are correctly made, switch on the unit.
- 21 -
@dbpower.co support@dbpower.co
Loading and Playing a Disc
1. After connecting power to the unit, set the power switch to the ON
position.
2. Push [OPEN] to open the disc tray. Place a disc in it with the label
side facing up.
3. Close the disc tray. The unit will load the disc and start playing.
MP3/MPEG4 Disc Playback
After the unit loads an MP3/MPEG4 disc, a menu showing the contents
of the disc will display on the screen.
1. Press the direction key [UP]/[DOWN] to select a file or a folder.
2. Press [OK] to enter the selected folder. The files/folders within it
will be listed.
3. Press [OK] to begin playing the selected file.
4. When the disc is stopped press [LEFT] to return to the previous
menu.
3. Close the disc tray. The unit will load the disc and start playing.
USB DRIVES & SD/MMC CARD PLAYBACK
Insert a USB drive or a card reader into the USB port.
Press [SOURCE SELECT] to select USB mode to play the readable files
from the source. Insert a SD/MMC card into the SD/MMC card port.
Press [SOURCE SELECT] to select MCR mode to play the readable files
from the source.
To Next Page
Loading...