dbx DriveRack PA2 - Page 32

30
®
• BAND(1–8) FREQUENCY [20 Hz – 20 kHz]
This parameter adjusts the center/cutoff frequency of the selected EQ band.
• BAND(1–8) GAIN [-12 dB – +12 dB]
This parameter adjusts the gain of the selected EQ band.
• BAND(1–8) Q [0.1 – 15.909]
This parameter is only available with BELL type filters and adjusts the width of the selected PEQ filter. Lower Q settings
provide wider filters, affecting a wider range of frequencies when adjusted. Higher Q settings provide narrower filters, which
affect fewer frequencies when adjusted.
• BAND(1–8) SLOPE [3 dB/Octave – 14.295 dB/Octave]
This parameter is only available with LOW SHELF or HIGH SHELF type filters and adjusts the slope rate of the filter
beyond the cutoff frequency. Lower settings yield a more gradual slope. Higher settings produce a steeper slope.