DC MONT DC-MPPT-MPK2-40A - Parameter Setting

MONT
On the main display, long press to enter interfaces 01. Short press / to enter the last / next
interface. On each interface, short press and the character will flash. Short press / to
decrease / increase the character. To confirm the setting, you can long press and it will go back
to the main interface automatically, or short press and it will enter the next interface.
PARAMETER SETTING
M
M
M
M
00:
02:
04:
06:
08:
10:
12:
14:
16-23:
25:
Working Interface
Battery Voltage(12/24/36/48V Auto Recognized)
Float Charge Voltage Setting
Absorption Charge Time Setting
Equalization Charge Time Setting
Lithium-Ion Battery Charge Recovery Voltage Setting
Discharge Recovery Voltage Setting
Load Working Time After Dark
Load Time Period Control & Time Setting
Communication Address Setting
01:
03:
05:
07:
09:
11:
13:
15:
24:
26:
Battery Type Setting
Battery Capacity
Absorption Charge Voltage Setting
Equalization Charge Voltage Setting
Lithium-Ion Battery Constant Voltage Setting
Discharge Cutoff Voltage Setting
Load Working Mode Setting
Load Working Time Before Dawn
Temp. Compensation Coefficient Setting
Baud Rate Setting