Dea 203RR - Built-in Radio Receiver

203 RR
R
Operating instructions and warnings
16
1
By pressing on the key the gate/door must open, by pressing on the key the gate/door must close. If this does not
happen, you must swap the two motor cables (input 7 and 9). Only if you use limit switches, first position the gate/door where
you want it to stop in closing and then adjust the closing cam so that it presses on the limit switch associated to it in that point.
Then position the gate/door in the opening position and adjust the opening cam so that it presses on the limit switches asso-
ciated to it in that point.
Instructions Function
Display
The control board is ready to receive instructions
Door/gate positioning
Scroll down the parameters until you visualize procedure P001
Confirm! The control board is ready for the positioning of the gate/door
Position gate/door in its standstill position after opening
1
Confirm! The control board has memorized the gate/door position
Motor stroke memorization
Scroll down the parameters until you visualize procedure P003
Confirm! The control board awaits a further confirmation
Confirm by pressing on the OK key for a few seconds! The procedure starts
Now the gate/door starts to close at a slow speed until it reaches the
stroke end while closing (or the limit switch).
On the display you will read “P003”. Motor stroke memorization done!
Scroll down the parameters until “----”. The control board awaits further instructions
8.3 Built-in radio receiver
DEA 203RR control board includes a 433,92MHz built-in radio receiver accepting both transmitters with
HCS coding (complete rolling code or just fixed part), and HT12E dip-switch coding.
• The type of coding is selected by programming the working parameter n° 8 “type of coding” (see Table
2 Parameters)
• The receiver memory capacity can contain up to 100 different transmitters.
WARNING If during the door opening you have no access to the push buttons of the control
board, you may configure and memorize the stroke by using the buttons of a 4-channel remote
control stored in memory
Instructions Function
Display
The control board is ready to receive instructions
Door/gate positioning and Motor stroke memorization
Scroll down the parameters until you visualize procedure
P001
Confirm! The control board is ready for the positioning
of the gate/door
Position gate/door in its standstill position after opening
1
Confirm! Now the gate/door starts to close at a slow
speed until it reaches the stroke end while closing (or
the limit switch).
On the display you will read “P003”. Motor stroke memo-
rization done!
Scroll down the parameters until “----”. The control board
awaits further instructions