Dea GEKO - Control Board Standard Programming

G E K O
EN
15
5.2 Control board standard programming
1 Power Supply
Give power supply, the display shows the following symbols “ ”, “ ”, “ ” and then “----”
2 Messages concerning working status
1. Press on the key;
2. Check that the display shows the correct outputs status.
3 1 or 2 operators operating selection
1. Scroll down the parameters until you visualize P020;
2. Confirm by pressing on the key;
3. By pressing on and , keys, set up:
- d001=for 1 operator mode;
- d002=for 2 operators mode;
4. Confirm by pressing on the key (display shows again
P020).
4 Learning of operators stroke
4.1 Positioning leaf 1
1. Scroll down the parameters until you visualize P001;
2. Confirm by pressing on the key;
3. By pressing (open) and (close) keys (if this does not
happen, you must swap the two motor 1 cables), position
leaf n.1 in its standstill position while opening;
4. Confirm by pressin on the key (display shows again P001).
4.2 Positioning leaf 2 (only for 2 operators)
1. Scroll down the parameters until you visualize P002;
2. Confirm by pressing on the key;
3. By pressing (open) and keys (if this does not happen,
you must swap the two motor 2 cables), position leaf n.2 in
its standstill position while opening;
4. Confirm by pressing on on the key (display shows again
P002).