Dea GEKO - Page 18

G E K O
16
4.3 Learning
1. Scroll down the parameters until you visualize P003;
2. Confirm by pressing on the key;
3. When the symbol “ ” flashes, press on the key for a few seconds;
4. Release the key once the symbol “ ” stops flashing, the learning procedure starts;
5. Wait for the leaf (or leaves when using 2 operators) stops on the closing stroke end;
6. On the display you will read “----“. Motor stroke memorization done!
5 Transmitters learning
5.1 Transmitters coding selection
1. Scroll down the parameters until you visualize P019;
2. Confirm by pressing on the key;
3. Select the type of transmitter by scrolling and keys:
- d000=fix rolling-code (suggested);
- d001=complete rolling-code;
- d002=dip-switch;
4. Confirm by pressing on the key (display shows again
P019).
5.2 Learning
1. Scroll down the parameters until you
visualize P005;
2. Confirm by pressing on the key;
3. When the symbol “ ” flashes,
press on any key of the transmitter
you want to memorize;
4. The display visualizes the number of
the transmitter just memorized and
then “ ” flashing;
5. memorize all necessary transmitters
repeating this procedure from step 3;
6. Wait 10 seconds before quitting the
memorization mode, display shows
now “----“.
6 Adjustment of operating parameters
If you need to modify the operating parameters (force, speedness
etc..):
1. Scroll down the parameters until you visualize the destre para-
meter (i.g. P022);
2. Confirm by pressing on the key;
3. By pressing on and , set up the desired value (refer to
“Operating parameters” table on page 21);
4. Confirm by pressing on the key (display shows the para-
meters previously selected).
7 Programmazione conclusa. L’automatismo rimane in attesa di comandi.
ATTENZIONE Alla fine della procedura di programmazione, agire sui tasti e fino alla comparsa del simbolo “----“, l’auto-
matismo è ora nuovamente pronto per le manovre.