Dea GEKO - Page 22

G E K O
20
PAR. PROCEDURE SETTABLE VALUES
PROGRAMMING PROCEDURES
Positioning of operator 1
Positioning of operator 2 Memorization of the motors’ stroke Deletion of transmitters Transmitters memorizing Search and deletion of a transmitter Loading of standard parameters: the list is up dated with factory settings DEA_NET net learning (not available at the moment)
PAR. PARAMETER DESCRIPTION SETTABLE VALUES
DEFAULT VALUES
(for different standards
of installation)
Swing gate
INPUTS CONFIGURATION PARAMETERS
INPUT_3 selectioning input type •000:IN3type=freecontact
•001:IN3type=constantresistance8K2
(free contact)
INPUT_1 operating selection •000:NONE(unusedparameter)
•001:START(start) •002:PED.(pedestrian) •003:OPEN(separatedopen) •004:CLOSE(separatedclose) •005:OPEN_PM(manpresentopen) •006:CLOSE_PM(manpresentclose) •007:PHOTO(photocell) •008:SAFETY(safetyrib) •009:STOP(lock) •010:FCA1(openinglimitswitchesMot1) •011:FCA2(openinglimitswitchtesMot2) •012:FCC1(closinglimitswitchesMot1) •013:FCC2(closinglimitswitchesMot2)
IN1
(START)
INPUT_2 operating selection IN2
(PHOTO)
INPUT_3 operating selection IN3
(STOP)
INPUT_4 operating selection IN4
(PED)
INPUT_5 operating selection IN5
(NONE)
Allocation of CHANNEL 1 of remotes •000:NONE(unusedparameter)
•001:START(start) •002:PEDESTRIAN(pedestrian) •003:OPEN(separatedopen) •004:CLOSED(separatedclose) •005:OPEN_PM(manpresentopen) •006:CLOSED_PM(manpresentclose)
CH1
(START)
Allocation of CHANNEL 2 of remotes CH2
(NONE)
Allocation of CHANNEL 3 of remotes CH3
(NONE)
Allocation of CHANNEL 4 of remotes CH4
(NONE)
Selection of type of remotes •000:HCSfix-code
•001:HCSrolling-code •002:Dip-switch
OPERATORS
CONFIGURATION
PARAMETERS
Selectioning operators number •001:oneoperator
•002:twooperators
Selected work with or without encoders. CAUTION: Remember to correctly set the jumpers J5 and J9 (see table 1) WARNING: J5, J9 and P021 must be set correctly before performing the procedure for programming
•000:motorswithencoder •001:engineswithoutencoder