EasyManua.ls Logo

Dea LIVI 803E - 9NET - Ordering Spare Parts

Dea LIVI 803E - 9NET
40 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
L I V I
Operatinginstructionsandwarnings
10
4.6 Training
After installation and setting, the correct operation of the
completeautomatismmust becarefullyillustrated tothefinal
user.
The LIVI gate operator requires careful instruction on the
releasemechanism(see“Enclosures”)inparticularandtheres-
pectivemaintenanceschedule(seePoint4.5.6.).
WARNING Awareness of the operation of theLIVIkey-re-
leasemechanism(seeF9Page32)isessentialforallusersof
theautomatismbecausethefailuretousethedevicequickly
duringemergenciescanjeopardisepeople,animalsandpro-
perty.EnclosureItotheseinstructions,whichtheinstalleris
requiredtodelivertothefinaluser,illustratesoperationand
canbedetached.
4.7 Inappropriate use
Chapter“4.4Appropriateconditions ofuse”describesthe
conditionsforwhichtheproducthasbeendesignedandtested.
Theproductmustneverbeusedforotherpurposes.
WARNINGTheuseoftheproductunderunusualconditions
notforeseenbythemanufacturercancreatesituationsofdan-
ger,andforthisreasonalltheconditionsprescribedinthese
instructionsmustberespected.
WARNING Under no circumstances must the product be
usedinexplosiveatmospheresorsurroundingsthatmayprove
corrosiveanddamagepartsoftheproduct.
5 SPARE PARTS LIST
Thelistofsparepartsthatcanbeordered(Pages28,29and
33)isadetailedlistthataccompaniestheexplodedviewofthe
productandmustbeusedtoorderspareparts.
Thefollowingdatamustalwaysbeprovidedwhenordering
spareparts:
• thecodeoftheproduct(seenontheproductlabel;seeF5,
Page31),
• thepart’spositionnumberintheexplodedview,
• ifavailable,theproduct’spurchasedatemaybeusefulin
somecases.
6 COMPLETE CLOSING ASSEMBLY
Thischapterillustratesthetypicalinstallationofacomple-
teautomatismfor thepurpose ofinforming andassistingthe
installerintheselectionofthevariouspartstobeusedincom-
pliancewithMachineryDirective(2006/42/CE)andEuropean
SafetyStandards(EN14453-EN12445)forgateinstallation.
Thedataprovidedinthischapterareneithercompletenor
exhaustive,andDEASystemdeclinesallliabilityforanyerrors,
omissionsorinaccuraciesthatmayoccur.
6.1 Minimum level of protection provided by the
safety edge
Theriskofgettingcrushedbetweenthegateandthefence
orwalland/orotherfixedpartsisamongthemostseriousrisks
tobeconsideredwhenautomatingaslidinggateis.Anappro-
priatetypeofoperatingcontrolboardmustbeusedaccording
tothegatetypeanduseagainstsuchrisk,asprovidedforbythe
quotedregulations(see“OPERATINGCONTROL”table).
6.2 Crushing in the opening area
Theriskofcrushingcanalsoariseintheareabetweenthe
gatebeing openedandthe wallorotherconstructionbehind
it. F10 on Page 32 provides the measurements that must be
respectedwhenevermeasuresarenottakentolimittheimpact
forceorwheneverpresencedetectionsystemsarenotused.
6.3 Impact in the opening/closing area
Installapairofphotocellsononeortheothersideofthe
gateoronbothinordertoavoidtheriskofimpactwiththegate
intheclosingarea.(recommendedheight:500mm)inorderto
detectthepresenceofthetestparallelepiped(height:700mm)
positionedasshowninF11onPage32.
Note.Thepresencedetectiontestsampleisaparallelepiped
with3sideswithlight-colouredreflectingsurfacesand3sides
withdark-coloured,opaquesurfaces.
Makesurethereisnoconflictwhenthephotocellsareinstal-
ledonbothsides.Thesystemworkingonthegatesidewherethe
testsampleispositionedmustdetectalltestobjects.

Related product manuals