37
CONFIGURATION OF THE CONTROL PANEL
The universal control unit Net24N can be used for the management of the following types (
) of closures motorized by DEA
System: swing and sliding gates, overhead doors and barriers.
In order to ensure maximum adaptability to each
of closure, the control board provides an initial procedure, performed only at
the first turn, for the optimal configuration of inputs, outputs and parameters (see diagram
). Once configured, the control panel will
operate in the mode “dedicated” to the
of selected closing. After performing the initial configuration it is sufficient to execute the
standard programming for the installation on which it is operating.
All settings remain in memory even in the case of subsequent flare-ups (see diagram
).
If necessary the
of configured closing can be later adjusted following diagram .
FIRST CONTROL BOARD IGNITION
Configuration after the first ignition
For the first control panel ignition, proceed as
follows:
1. Apply power, the display shows in sequence the
writing “
” and “ ” flashing;
2. Press the
button and hold for 5 seconds until
the display shows
on the display;
3. Acting on the
and keys, select the desired
configuration depending on the type of installa-
tion (es.
) and confirm by pressing the
button;
At this point, the selection will be stored and
reloaded each time in the future.
4. Follow signs, “
”, “ ” followed by the
symbol of closed gate “----”.
Following ignitions
If you have already saved a configuration, pro-
ceed as follows:
Apply power, the display shows in sequence the
writing “
”, “ ”, “ ” followed by the
symbol of closed gate “----”.
Modify the existing configuration
If you have already saved a configuration and
you want to change it, proceed as follows:
1. Hold down the button and give power, the
display shows in sequence the writing “
”
and “
” flashing;
2. Press the
button and hold for 5 seconds until
the display shows
(the value changes to
match the previous configuration used) on the
display;
3. Acting on the
and , select the new desired
configuration depending on the type of installa-
tion (es.
) and confirm by pressing the
button;
Stop the reconfiguration procedure prior
to confirmation, involves loading the pre-
vious configuration by the control panel wi-
thout any modification.
To Next Page
Loading...
