Dea NET24N - Selection of Direction of Motion; Motor Stroke Learning; Transmitters Learning

42
5 Selection of direction of motion
1. Scroll down the parameters with and keys
until you visualise P063;
2. Access the parameter by pressing the
key;
3. Acting on
and keys, set:
- d000=motor in standard position (on the left of
the gap);
- d001=motor in inverted position (on the right of
the gap);
4. Confirm your choice by pressing the
key (display
returns again to P063).
6 Motor stroke learning
1. Scroll down the parameters with and keys until you visualise P003;
2. Access the parameter by pressing the
key;
3. When “
” flashes, continue pressing the key;
4. Release the
key when “ ” stops flashing; the learning procedure starts;
5. Wait for the door searches and stops on the opening stop and then on the closing stop.
If you want to anticipate the stopping strokes in opening, you can manually intervene by giving an impulse to “Start” button
(or pressing the “OK” on the control panel) simulating the stroke.
6. Once the procedure is ended, the display will show “----“.
7 Transmitters learning
7.1 Transmitters coding selection
1. Scroll down the parameters with
and keys until you vi-
sualise P027;
2. Confirm by pressing on the
key;
3. Select the type of transmitter by scrolling
and keys:
- d000=fix rolling-code (suggested);
- d001=complete rolling-code;
- d002=dip-switch;
4. Confirm by pressing on the
key (display shows again P027).
Warning: If you need to vary the type of encoding, and only
if other remotes with different encoding are memorized, you
need to erase memory (P004) AFTER you have set the new
encoding.