Decathlon RIVERSIDE 520E - Page 8

8
MOTOR
The motor «F» of your power-assi󰘵ed bike is a brushless-type motor with mechanical reduction, which means you
can have high torque and less resi󰘵ance (quieter motor). The A-weighted emission sound pressure level at the driver
ears is less than 70 dB(A). Motor power is limited to 250 W maximum.
BATTERY AND CHARGER
Battery properties and warranty
All batteries in our electric bikes use Lithium-Ion cell technology and have no memory e󰘯ect. (the battery can be
recharged at any time; there’s no need to wait until it’s completely discharged).
Recharging the battery after each use is recommended.
Charge the battery to 100% prior to its 󰘰r󰘵 use.
Battery Charger
Battery 36 V / 14 Ah
504Wh
Input: 100-240 V
Output: 42 V
Your battery is guaranteed for 2 years or 500 charging and discharging cycles (1 cycle = 1 charge from 0% to 100% +
1 discharge from 100% to 0% or 1 cycle = 2 charges to 50%) subject to compliance with the proper conditions of use
and 󰘵orage. Never use a di󰘯erent charger to the one supplied by DECATHLON for this bike model. Use of another
charger may damage the battery or cause serious incidents (sparks, outbreak of 󰘰re)
Battery life
The battery life of your electric bike depends on numerous factors:
- The weight on the bike: Overloading the bicycle will reduce the battery life (panniers, baby carrier etc).
- Use: Depending on the human input provided during pedalling, battery life will increase or decrease.
- The type of route ridden: Battery life will drop when cycling uphill.
- Tyre pressure: Battery life will be better with tyres in󰘱ated between 4 and 5 bar.
- Outside temperature: Cold weather reduces battery life.
- The mode of assi󰘵ance used: It is advisable to reduce the power assi󰘵ance mode when the battery charge is low.
- The selected transmission ratio: On 󰘵eep slopes, it is advisable to choose the right gear to reduce the e󰘯ort re-
quired from you and the motor.
- Complying with the proper conditions for charging and 󰘵oring the battery: For a cycli󰘵 weighing 75kg, adhering to
these be󰘵 practices, and cycling in light wind using mode 1, the battery range of the RIVERSIDE 520E is e󰘵imated to
be around 100km.
5
Lighting button
Short press the power button to turn the front and rear lights, and display backlight, on
and o󰘯.
Go to the settings by holding the button down for a few seconds
6 Speed indicator**
7
6
KM
«Walk assi󰄋» mode:
For walking beside the bicycle in walk assi󰘵 mode, up to 6 km/h, without pedalling.
Please note that this mode should not be used when riding the bicycle
8
ODO: Records the total di󰘵ance travelled. It cannot be reset to zero.
TRIP: Records the partial di󰘵ance travelled.
TRIPtoGO: Remaining di󰘵ance that may be covered with the power assi󰘵ance mode.
9 Di󰄋ance indicator
10
Units:
kilometres or miles
11
Lighting indicator:
Appears on the screen when the lights are on
12
Five battery levels.
When the battery level is low, the indicator 󰘵arts to 󰘱ash.
13
Additional battery and sy󰄋em information:
Indicates the battery charge level as a percentage
Setting :
Hold the «Lighting» button down for a few seconds to enter or quit the settings
Short press on the «+» or «-» buttons to select the desired setting.
- Choice of units (km/h or mph)
- SLEEP = Selecting the time before the screen goes to sleep (in minutes)
(only available on certain screen versions)