Decathlon RIVERSIDE 520E - ERROR CODE B

18
26 / 80 / 82 /
83 / 84
Programme error in the controller Switch o󰘯 the bike and switch it back on again.
30 Walk mode error
Switch o󰘯 the bike and switch it back on again. Take
care not to overload the motor when in walk mode
(moderate slope, no load on the bike).
40 / 41 / 44
Over-voltage or overheating of the
motor
Allow the motor to cool by pedalling more gently or
lowering the assi󰘵ance mode
42 / 44 Motor error or short circuit
Check that the screen connections are properly plug-
ged in. Re󰘵art the bike.
45 Error corrected during use Switch o󰘯 the bike and switch it back on again.
46 Motor error
Check that the motor connections are properly plug-
ged in. Re󰘵art the bike.
60
Communication error between the
screen and the controller
Check that the screen connections are properly plug-
ged in. Re󰘵art the bike.
70 / 71 / 72
/ 73
Torque sensor error
Switch o󰘯 the bike and switch it back on again.
81 Unrecognised speed
Check that the motor connections are properly plug-
ged in. Re󰘵art the bike.
200 / 201 / 202 Torque or cadence sensor error Switch o󰘯 the bike and switch it back on again.
ERROR CODE B
Error code De󰄈nition Solutions
16 / 17
Abnormal voltage in the torque sensor
Turn o󰘯 the bike and remove the battery. Replace the
battery and turn on the bike. If the fault has not disap-
peared, go to a Decathlon workshop for repair.
32 / 33
Motor fault
Check the positioning and condition of the motor
connectors. If the fault has not disappeared, go to a
Decathlon workshop for repair.
48 Speed sensor fault in the motor. Visit a Decathlon 󰘵ore for possible motor diagno󰘵ics
49
Cadence sensor malfunction
Turn o󰘯 the bike and remove the battery. Replace the
battery and turn the bike back on. If the fault has not
disappeared, go to a Decathlon workshop for repair.