Dectron, Inc. March 2012
Owner’s Manual
DSH/DSV/RSH/DBH/RBH Series Dehumidifier
Remove Shipping Blocks T.A.B.
Data subject to change without notice.
175
Risk of contact with moving parts. Can cause injury or death.
This product contains rotating parts and V-belt drives. Some installation, service, and
maintenance procedures could expose personnel to the risk of injury or death from
contact with these parts.
Using only approved devices (e.g. locking safety switch), disconnect, lockout, and
tagout all sources of electrical energy before working inside the unit cabinet. Allow
adequate time for rotating parts to stop. Follow all applicable safety regulations.
WARNING
DECTRON
Remove all loose materials from the inside of the unit.
Some units may have optional spring-mounted blower
frames, as shown here.
In this case, loosen the pair of forward spring bolts (A) and
the pair of rear spring bolts (B), then remove any wooden
shipping blocks (C). Do not
leave any loose materials
inside the unit.
Adjust the spring bolts (A) and (B) to keep slack in the
fabric duct section (D). Use shims under the rear springs if
necessary.
C. wooden blocks
B. rear
spring bolt
A. forward
spring bolt
D. fabric duct
section
Sample
Layout and
appearance
may vary.
Some units may ship with wooden spacer blocks to maintain component positions during shipping. Open the unit
access panels or doors and remove any wooden blocks.
Where wire or plastic wraps are used to hold the wooden blocks in place, remove them also. Do not
leave loose
materials inside the unit.
NOTE: Do not remove any perforated-channel braces or other metal braces unless specifically instructed
to do so.
NOTICE
Risk of property damage.
Some units may ship with shipping blocks and/or other temporary restraints inside the unit. If these
shipping blocks and restraints are not removed prior to starting the blower, they may come loose and
damage parts of the unit and/or parts of the duct system.
T.A.B.
To Next Page
Loading...
Need help?
General
