-
Cooking with delayed start and chosen
cooking end time
Proceed as with programmed cooking.
- After setting the cooking time, press the “ ”
button until the end of cooking indicator flashes
“ ”.
The display flashes to indicate that you can
now adjust the setting (fig.
1).
- Press the
+
or
-
button to set the desired
cooking end time.
Example: end of cooking at 13:00 (fig.
2).
The cooking end time is automatically
recorded after a few seconds.
The cooking end time display stops flashing.
A
fter these 3 steps, the oven heating is
delayed so that cooking ends at 13:00.
At the end of cooking (end of programmed
time),
- the oven turns off,
- the cooking time indicator and 0:00 both
flash (fig.
3),
- a series of beeps sounds for a few minutes.
Press any button to stop the beeping.
The display shows the time once again when
the function selector switch is returned to 0
(fig.
4).
The light inside the oven turns on when
cooking starts and goes out when cooking
stops.
fig.1
fig.2
fig.3
fig.4
PROGRAMMED COOKING
•
When the cooking is delayed in a
cold oven
(by pulsed far or combined cooking), the
cavity lights up when cooking starts and stays lit until cooking ends. The fan keeps working
when the cooking has finished, until the oven has cooled down.
When the cooking is delayed in a
h
ot oven
(by pulsed far or combined cooking), the
cavity lights up when cooking starts and stays lit until cooking ends. The fan starts working
when the programme starts and keeps working until the oven has cooled down.
99641441_A_ML.qxp 12/04/2007 10:57 Page 61
To Next Page
Loading...
Need help?
General
