What to do if the SCB is not found on my DeDietrich EVODENS PRO Amc 45 Boiler?
If the SCB is not found in your DeDietrich Boiler, it might be due to a bad connection. Check the wiring and connectors. If the connections are secure, the SCB may be faulty and require replacement.
What to do if there is no flame during operation of my DeDietrich EVODENS PRO Amc 45?
If you're experiencing no flame during operation with your DeDietrich Boiler, it could be due to a configuration error leading to no ionization current or poor combustion. Try purging the gas supply to remove air and ensure the gas tap is fully open. Check the gas supply pressure and the operation and setting of the gas valve unit. Also, verify that the air inlet and flue gas discharge flues are not blocked and that there is no recirculation of flue gases.
What to do if I see a water pressure warning on my DeDietrich Boiler?
If you receive a water pressure warning on your DeDietrich Boiler, it means the water pressure is too low. You should check the water pressure to resolve this issue.
How to troubleshoot an open outdoor temperature sensor on a DeDietrich Boiler?
If the outdoor temperature sensor of your DeDietrich Boiler is open, it could be due to a bad connection. Check the wiring and connectors. Also, verify the sensor is correctly fitted and replace the sensor if it's faulty or not present.
What to do if the outdoor sensor is not detected on my DeDietrich EVODENS PRO Amc 45 Boiler?
If the outdoor sensor is not detected by your DeDietrich Boiler, ensure the sensor is properly connected. If it's not connected, connect it. If it's connected incorrectly, correct the connection.
What should I do if the water pressure sensor is not detected on my DeDietrich EVODENS PRO Amc 45?
If the water pressure sensor is not detected by your DeDietrich Boiler, make sure the sensor is properly connected. If it is not connected, connect it. If it is connected, ensure it is connected correctly.
What should I do if the SCB is not found and the manual says to do an auto-detect on my DeDietrich EVODENS PRO Amc 45?
If the SCB is not found on your DeDietrich Boiler, carry out an auto-detect.
How to fix the 'SCB not found' error on my DeDietrich Boiler?
If the SCB is not found on your DeDietrich Boiler, perform an auto-detect to resolve the issue.
What is the solution if the SCB is not found on my DeDietrich Boiler?
If your DeDietrich Boiler indicates that the SCB is not found, the solution is to carry out an auto-detect.
General| Type | Condensing Boiler |
|---|---|
| Power Output | 45 kW |
| Fuel | Gas |
| Sound Power Level | 52 dB(A) |
| Warranty | 2 years |
| Fuel Type | Natural Gas |
| Efficiency | Up to 109% |
| Output Range | 45 kW |
To Next Page