The INNOVENS PRO MCA 160 boiler can be supplied with a choice of either
of the following two control panels:
- DIEMATIC EVOLUTION: according to the options connected, this enables
command and control of up to 3 heating circuits according to the outside
temperature + 1 DHW circuit. It also allows optimised management of
combined systems and the control of 2 to 8 boilers in cascade configuration
(see page 5) when combined with boilers with the IniControl 2 panel (or
DIEMATIC EVOLUTION).
- IniControl 2: for operation via a 0-10V input, supplied with this panel
as standard. It is used as a secondary boiler as part of an installation in
cascade configuration, actuated by a boiler equipped with the DIEMATIC
EVOLUTION panel or in a cascade system where each boiler is controlled
via a 0-10V input.
Different air-flue gas connection configurations are possible; we offer
connection solutions using a horizontal or vertical forced flue, on a chimney
or bi-flow. MCA 160 units can be fitted in cascade only, or in combination
with MCA 45-115 boilers.
Complete hydraulic systems for connection of a cascade of 2 to 8 boilers
are available.
Operating cOnditiOns
Maximum operating pressure: 4 bar
Maximum operating temperature: 90°C
Safety thermostat; 110°C
Power supply: 230 V/50 Hz
International Protection marking: IP X1B
apprOval
B
23
- B
23P
/B
33
- C
13x
- C
33x
- C
93x
- C
53
- C
63
- C
83
gas categOry
Equipped and preconfigured to operate using natural gas and propane
(with conversion kit)
NOx class: 6 (EN 15502-1)
WALL-MOUNTED GAS CONDENSING BOILER
MCA 160: from 34.7 to 161.6 kW for heating only
Heating and domestic hot
water using an independent
tank
Condensation
All natural gases
Propane
CE identification no.:
0063CQ3781
MCA 160 MCA 160 installed in cascade
INNOVENS PRO MCA 160
PROJECT
To Next Page
Need help?
General
