Dee Zee DZ 951550 User Manual

IR-HOUSING-ASSEML X2 IR-HOUSING-ASSEMR X2
THERE IS NO BUNGEE BOX IN THE 5 FT. APPLICATION
6 FT.
MOUNTING HOOK SECTION CAP
EDC
BUNGEE BOX
INVIS-A-RACK INSTALLATION INSTRUCTION
DZ 951550, DZ 951600, DZ 951800
A B
DRIVER FRONT / PASSENGER REAR PASSENGER FRONT / DRIVER REAR
8 FT.
VARIES X2 DZE-539-150CP X8 ECIR4 X4
FGT 32 16 FT. PN 220 X8 PN 90 X8
FOAM GASKET 3/8" BOLT 3/8" NUT
F G H

Dee Zee DZ 951550 Specifications

General

Brand	Dee Zee
Model	DZ 951550
Category	Other
Language	English

Summary

Initial Rack Assembly and Placement

Prepare Rack Components

Apply foam gasket to rack assemblies and bungee boxes, and assemble bungee boxes if needed.

Mount First Rack Assembly

Position the first rack assembly on the driver's side of the truck bed, near the cab.

Install Hold Down Clamps

Assemble and slide four hold down clamps into the bottom channel on the back side.

Position Clamps by Bed Length

Locate and position hold down clamps based on truck bed length for optimal fit.

Securing the Rack Assembly

Tighten Rack Fasteners

Tighten bolts with Allen wrench and nuts with open wrench to secure the rack assembly.

Repeat Mounting on Second Side

Repeat the installation steps for the other side of the truck bed.

Rack Operation: Deployment and Stowing

Deploying the Invis-a-rack

Pull up the top section, extend material arms, and engage cross bars for deployment.

Stowing the Invis-a-rack

Depress push buttons to retract cross bars, material arms, and rack sections to stow.