53
4.3 Troubleshooting >>
4 / APPENDIX
Issues
Possible Causes
Suggested Solutions
Motors won't
start.
Weak GPS signal.
(1)Ensure you're operating in an area with strong GPS reception.
(2)For indoor operations, press and hold the RTH button to switch to ATTI
mode.
The drone's battery is running low
(evidenced by the continuous flashing of
RED light on the rear of the drone).
The compass isn't calibrated (evidenced by the
continuous flashing of GREEN light on the rear of
the drone).
Conduct a compass calibration. For step-by-step instructions, refer to
the "Compass Calibration" section in the user manual.
Compass interference
Propeller deformation or damage
Replace with new propellers.
Gimbal protection activated due to not
removing the gimbal cover before powering on.
Ensure the gimbal cover is removed before powering on.
Drone is not in a level position.
In compass calibration mode.
The gimbal doesn't function during compass calibration. After calibration, place
the drone on a level surface and wait for the gimbal to stabilize and re-center.
Place the drone on a level surface before turning it on and wait for the
gimbal to complete its self-check.
Drone placed on uneven surfaces like
grass or sand.
Position the drone levelly on a landing pad or switch to another even
surface. Ensure there's ample space below the gimbal and avoid obstacles
that might affect its stabilization.
Charge the drone with an OEM charging cable.
Operate the drone in open spaces free from obstructions.
(1)Manually land the drone immediately and recalibrate the compass
(2)Try operating in a different location, ensuring you're away from buildings,
power lines, and signal towers.
GPS signal instability due to flying near buildings
or in areas with obstructions.
Unstable flight
or abnormal
posture
Gimbal cannot
stabilize.
(See page 24)
(See page 09)
(See page 21)
Gimbal is under self-check (front status indicator
blinks blue, rear blinks red).
Wait 8 seconds for completion; indicators will then turn solid.
To Next Page
