8
PosiTest AT-A
1. Push the actuator handle completely down into the actuator
assembly. Place the actuator over the dolly head and attach
the quick coupling to the dolly by reaching through the holes
in the actuator and lifting the coupling. Release the quick
coupling when the dolly head is completely engaged.
2. Press the button to power-up the instrument if necessary.
3. Verify Pull Parameters (pg. 11) are set to the preferred dolly
size, pull rate, pull limit and hold time. Change if necessary.
How to Measure
Carousel:
indicates the current view. Swipe horizontally
or use arrow keys to switch between views.
Pull Parameters
(pg.11)
WiFi Bluetooth USB
(Status icons)
Pull Chart
displays
pressure
over time
Current
Reading
Touch Screen Display
If recording of test results is desired, a memory batch
must be opened prior to the test. Select New Batch from the
Memory menu (pg. 11).
NOTE:
Prepare the Instrument
Dolly
Size
Pull Rate
Limit
Hold Time
Use the touch screen to interact with menu options. Swipe
horizontally to navigate between views or vertically to move
between batch readings. Alternatively, the directional buttons can
be used for navigation.
Battery
(see pg.10)
Main View (shown with memory batch open)
To Next Page
Loading...
