8
Operation (continued)
7
Adjusting the LAMP MODE
Switch
The “LAMP MODE” switch determines the way the
lights will turn on when motion is detected.
Ƒ Security (“NORMAL”) - Light comes on instantly.
Ƒ BulbSaver (“SOFT”) - Light comes on dim and
gradually increases to full brightness. When the
light turns off it will gradually dim to half-bright,
pause, and then will continue dimming until the
light turns off.
Ƒ AlertFlash (“FLASH”) - Light ashes on then off
twice before turning on full brightness.
Ƒ Set the “LAMP MODE” to “NORMAL”, “SOFT”,
or “FLASH” position.
LAMP MODE
NORMAL SOFT FLASH
8
Using Manual Mode
Manual mode overrides the motion sensor (A) and
“ON-TIME” control so the light will operate full bright.
This feature only works at night and only for one night
at a time. The motion sensor (A) will reset to motion
sensing mode at sunrise. Manual mode can be toggled
on and off using a wall switch.
Ƒ To turn manual mode on, switch the light off
at the wall switch for 3 to 4 seconds and then
back on.
Ƒ To turn manual mode off, switch the light off
at the wall switch for 3 to 4 seconds and then
back on.
NOTE: If the power to the light xture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
Turn the switch
OFF for 3 to 4
seconds
Turn the
switch
back ON
Care and Cleaning
Ƒ To prolong the original appearance, clean with clear water and a soft, damp cloth only.
Ƒ Do not use paints, solvents, or other chemicals on this motion sensor. They could cause a premature
deterioration of the nish. This is not a defect in the nish and will not be covered by the warranty.
Ƒ Do not spray with a hose or power washer.
A
To Next Page
Loading...
