5 HOMEDEPOT.COM/HUBSPACE
Please contact 1-877-592-5233 for further assistance.
Installation (continued)
3
Testing the push button and
doorbell
NOTE: Do not permanently mount the push button until
the push button and doorbell are working properly.
NOTE: The push button and doorbell come synced from
the factory. The range of the wireless doorbell can vary
with location, temperature, and battery condition.
Ƒ Temporarily position the push button (B) where
it will be mounted.
Ƒ Press the push button (B) to verify the
doorbell(A) and push button (B) work properly.
Ƒ If the doorbell (A) does not sound, move the
doorbell (A) closer to the push button (B) and
test again.
4
Mounting the push button
NOTE: Remove material in screw holes (if needed) before
mounting with screws.
Use either screws (AA) or double-sided tape (BB) to
mount the push button (B).
Ƒ To mount with screws (AA), remove the back
of the push button (B) by pushing in the tab on
the bottom with a small screwdriver. Place the
push button back on the door jamb and mark
the two screw holes. Drill two 1/16 in. pilot
holes. Attach with screws (AA) and snap on the
front of the push button (B).
Ƒ When attaching the push button (B) with
double-sided tape (BB), remove the paper from
both sides of the double-sided tape (BB) and
apply to a clean surface.
Operation
1
Downloading the Hubspace™
app
Download the Hubspace™ app from the App Store or
the Google Play Store.
B
A
AA
To Next Page
Loading...
