(/fullviews/1749761/1749761_files/1749761-15.jpg)
sure the latch cam is upright before making any backset adjustment.
Turn to extend the latch bolt.
Turn back to retract the latch bolt.
2-3/4 should be visible.
C. Install the latch
B. Set the latch backset length
Flat head screwdriver
a.With the bolt extended, twist latch end 1/8 turn.
b.Pull as shown in the diagram.
(/fullviews/1749761/1749761_files/1749761-16.jpg)
Backset
Drive-in latch
(/fullviews/1749761/1749761_files/1749761-17.png)
Tap latch flush
Your experience on this site will be improved by allowing cookies. Allow cookies
To Next Page
Loading...