Page 7
Installation and connection
The product must be installed in accordance
with all local gas and electrical regulations.
The connection must comply with national
regulations.
The mains supply data must correspond
to the data specified on the type label of
the hob.
The power cable of your hob must comply
with the values in "Technical specifications"
table.
Risk of broken glass!
Do not put the ceramic hob down
on a corner or edge.
DANGER Risk of electric shock,
short circuit or fire by damage
of the mains lead!
The mains lead must not be
clamped, bent or trapped or come
into contact with hot parts of the
hob. If the mains lead is damaged,
it must be replaced by a qualified
electrician.
DANGER Risk of electric shock!
Before starting any work on the
electrical installation, please
disconnect the appliance from the
mains supply.
DANGER Risk of electric shock,
short circuit or fire by
unprofessional installation!
The hob may be connected to the
mains supply only by an
authorized qualified person and
the hob is only guaranteed after
correct installation.
Electrical connection
Connect the hob to a grounded outlet/line
protected by a fuse of suitable capacity as
stated in the "Technical specifications" table.
Have the grounding installation made by a
qualified electrician while using the hob with
or without a transformer. Our company shall
not be liable for any damages that arise due
to using the hob without a grounding
installation in accordance with the national
regulations.
Connecting the power cable
1. Single-phase connection only
Connect the wires as identified below:
Brown/Black cable = L (Phase)
Blue/Grey cable = N (Neutral)
Green/yellow cable = (E) (Ground)
To Next Page
Loading...
Need help?
General
