6 Quick User Guide
6.1 Preparing the machine
1. Make sure that the hoses are connected tightly.
2. Plug in your machine.
3. Turn the tap on completely.
4. Place the laundry in the machine.
5. Add detergent and fabric softener.
6.2 Programme selection
Select the programme suitable for the type,
quantity and soiling degree of the laundry
in accordance with the “Programme and
consumption table” and the temperature table
below.
6.3 Auxiliary function selection
Select the desired auxiliary functions before
starting the programme. Furthermore, you may
also select or cancel auxiliary functions that
are suitable to the running programme without
pressing the Start / Pause button when the
machine is operating. For this, the machine must
be in a step before the auxiliary function you are
going to select or cancel.
If the auxiliary function cannot be selected or
canceled, light of the relevant auxiliary function
will blink 3 times to warn the user.
6.4 Starting the programme
Press Start / Pause button to start the
programme.Programme follow-up light showing
the startup of the programme will turn on.
C
If no programme is started or no key
is pressed within 1 minute during
programme selection process, the
machine will switch to Pause mode and
the illumination level of the temperature,
speed and loading door indicator lights
will decrease. Other indicator lights
and indicators will turn off. Once the
Programme Selection knob is rotated or
any button is pressed, indicator lights and
indicators will turn on again.
6.5 Changing the selections
after programme has started
Switching the machine to pause mode
Press the Start / Pause button to switch the
machine to pause mode while a programme is
running. The light of the step which the machine
is in starts flashing in the Programme Follow-up
indicator to show that the machine has been
switched to the pause mode.
Also, when the loading door is ready to be opened,
Loading Door light will also illuminate continuously
in addition to the programme step light.
Changing the speed and temperature settings
for auxiliary functions
Depending on the step the programme has
reached, you may cancel or activate the auxiliary
functions; see, “Auxiliary function selection”.
You may also change the speed and temperature
settings; see, “Spin speed selection” and
“Temperature selection”.
C
If no change is allowed, the relevant light
will flash for 3 times.
Adding or taking out laundry
1. Press the Start / Pause button to switch the
machine to pause mode. The programme
follow-up light of the relevant step during which
the machine was switched into the pause mode
will flash.
2. Wait until the Loading Door can be opened.
3. Open the Loading Door and add or take out the
laundry.
4. Close the Loading Door.
5. Make changes in auxiliary functions,
temperature and speed settings if necessary.
6. Press Start / Pause button to start the machine.
6.6 Canceling the programme
To cancel the programme, turn the Programme
Selection knob to select another programme.
Previous programme will be canceled. End /
Cancel light will flash continuously to notify that
the programme has been canceled.
Pump function is activated for 1-2 minutes
regardless of the programme step, and whether
there is water in the machine or not. After this
period, your machine will be ready to start with the
first step of the new programme.
C
Depending on the step where the
programme was canceled in, you may
have to put detergent and softener again
for the programme you have selected
anew.
To Next Page
