Page 21
DANGER: Before replacing the oven
lamp, ensure that the appliance is
disconnected from mains and cooled
down to avoid the risk of an electrical
shock. Hot surfaces may cause burns!
The oven lamp is a special electric light
bulb that can resist up to 300°C. See
Technical specifications for details. Oven
lamps can be obtained from Authorised
Service Agents.
Position of lamp might vary from the
figure.
Replacing the oven light bulb
If your oven is equipped with a square lamp:
1. Disconnect the product from mains.
2. Remove the wire racks as described. See
diagram on following page.
Oven light
The oven light is switched on by the multifunction
selector switch and switches off when the knob
is returned to 0.
3. Remove the protective glass cover with a
screwdriver.
4. Unscrew oven lamp and replace it with
new one.
5. Install the glass cover and then the wire
racks.
If your oven is equipped with a round lamp:
1. Disconnect the product from mains.
2. Turn the glass cover counter clockwise to
remove it.
3. Remove the oven lamp by turning it counter
clockwise and replace it with the new one.
4. Install the glass cover
1
Inner glass panel
2
Outer glass panel
3 Plastic glass & hinge holder
As illustrated in figure, raise the inner glass panel (1)
slightly in direction A and pull it out in direction B.
When installing the inner glass panel (1), make sure
that the printed side of the panel faces towards the
inside of the oven. It is important to seat the lower
corner of inner glass panel into the lower plastic slot.
Push the plastic part towards the frame until you hear
a "click".
2. Using a screwdriver remove both screws at the top
of the door profile (one on each side).
3. Remove the door profile and carefully take out the
glass.
4. When refitting the glass ensure the bottom edge of
the glass is securely placed in the plastic slots.
Refit the door profile using the screws.
To Next Page
Loading...
