Page 16
ADDING FUNCTIONS TO THE
PROGRAMME
Half load and delayed start can be added to
an existing programme as follows:
• Select the programme by pressing the
programme selection button (4).
• Press the function button (5 or 6 or both).
• Start the programme by pressing the
Start/Pause/Cancel button (2).
PROGRESS INDICATOR
The wash cycle may be monitored by
observing the progress indicators (15)
• a= Washing.
• b= Drying.
• c= End of programme.
• At the end of the programme, the indicator
lights up and the remaining time indicator
(3) displays 0:00.
CANCELING A PROGRAMME
• Press the Start/Pause/Cancel button and
hold it down for three seconds to cancel a
programme that is running.
• Release the button when the start
indicator (12) starts flashing.
• After a few minutes. The machine will then
fulfill the necessary cancellation
operation .
• When the remaining time (11) displays
0:00 a new programme may be selected.
NOTE: Depending on when the
programme was cancelled, there may be
detergent and rinse aid residues left in the
machine.
CHANGING A PROGRAMME
• Press the Start/Pause/Cancel button (2) to
pause the machine.
• Select the desired programme by pressing
the programme selection button (4).
• Start the new programme by pressing the
Start/Pause/Cancel button (2) again.
The new programme will start where the
previous one left off. For example if the
previous one was in a rinse cycle, the new
one will resume in a rinse cycle. If you wish
the new programme to start from the
beginning ,you will first have to cancel the
previous programme as described under
“Canceling a programme”.
SALT INDICATOR (9)
• Please check the indicator (9) regularly.
If it lights up, the salt needs to be
replenished.
SETTING THE RINSE AID INDICATOR (10)
Using the rise aid indicator is optional and
this function may be switched on or off.
Proceed as follows:
• The machine must be switched off.
• Press and hold the 1/2 load button (5)
and then press the ON/OFF button (1)
to switch on.
• Keep the 1/2 load button pressed in and
release the ON/OFF button.
• Hold the 1/2 load button in for an
additional 3 seconds.
• The Rinse aid indicator (10) will come
on and the stored status appears on the
display as ON or OFF.
• You can change this status using the
Start/Pause/Cancel button .
• Depending on the status ON or OFF
when the machine is switched off, it will
remember the setting and either utilize
the indicator or not when next the
machine is switched on.
RINSE AID INDICATOR (10)
• Please check the indicator (10)
regularly.
• If it lights up, the rinse aid needs to be
replenished.
• If the status of the indicator is OFF, it
will not show even if the rinse aid
container is empty.
To Next Page
Loading...
