Page 17
OPERATING THE DISHWASHER.
• Plug the mains plug into a dedicated 15A
earthed wall socket.
• Open the water tap.
• Open the dishwasher door.
• Load the dishes.
• Check if both the upper and lower spray
arms rotate freely.
• Add the required amount of detergent to
the dispenser and close the dispenser lid.
• Close the dishwasher door.
• Press the ON/OFF button
• Check to see if water softening salt and/or
rinse aid need replenishing.
• Select the desired washing programme.
• Start the programme by pressing the Start/
Stop/Cancel button.
• Monitor progress via the time remaining
display and the progress indicators.
• The End of programme indicator will light
up.
• Switch the machine off by pressing the
ON/Off button.
• Close the water tap. (optional).
• Remove the plug from the wall socket
(optional).
• Open the door slightly and allow the
dishes to cool for about 15 minutes before
removing them.
• The Door should not be left in the fully
open position as this could present a
tripping hazard.
• Thereafter the clean dishes may be
removed.
WARNING
• Never open the dishwasher door while it is
running.
• Stop the dishwasher using the Stop/Start/
Cancel button.
• Thereafter the door may be opened
• Be careful to avoid the rush of hot steam
which may escape.
• Fix whatever required fixing or which
necessitated the door being opened.
• Close the door and press the Start/Pause/
Cancel button again.
The dishwasher will then resume operation.
Operating the dishwasher
14
To Next Page
Loading...
