Page 13
Note.This appliance is supplied ex-factory with
jets and air settings for use with LPG gas only.
Safety compliance with local requirements.
Installer’s details are to be filled in on page 23 of
this book
Temporary installation
Flexible hose connection from the gas appliance to
the cylinder can be made .
Ensure that pipe clamps are tightened correctly and
are of good quality.
x Flexible hose - Not supplied.
Any hose that is used to connect the stove to the
gas system shall comply with SANS 1156-2 or BS
3212.
x Gas cylinder - Not supplied.
For best results we recommend that gas cylinders
with a minimum capacity of 19kg be used.
x Regulator - Not supplied.
A 2.8-3.0 kPa LPG gas regulator which complies
with SANS 1237 must be used.
Permanent installation
Important information for the user
This appliance may only be installed by a
registered LP Gas installer. All registered
installers are issued with a card carrying their
registration number.
Ask to be shown this card before allowing the
installation to commence and make a note of the
installer QCC number on page 23 of this book.
Upon completion of the installation, the installer is
required to explain the operational details of the
appliance together with the safety instructions. You
will be asked to sign acceptance of the installation
and be provided with a completion certificate. You
should only sign for acceptance when the installation
is completed to your satisfaction.
Failure to comply with the above will render the
warranty invalid.
Note:
Your invoice is required in the event of you
wishing to make a warranty claim.
To Next Page
Loading...
