Page 11
Note.This appliance is supplied ex-
factory with jets and air settings for use
with LP gas only.
Safety compliance with local
requirements.
Installer‟s details are to be filled in on
page 19 of this book
Temporary installation
Flexible hose connection from the gas
appliance to the bottle can be made.
Ensure that pipe clamps are tightened
correctly and are of good quality.
Flexible hose - Not supplied.
Any hose that is used to connect the
stove to the gas system shall comply with
SANS 1156-2 or BS 3212.
Gas bottle - Not supplied.
For best results we recommend that gas
cylinders with a minimum capacity of 19kg
be used.
Regulator - Not supplied.
A 2.8-3.0 kPa LP gas regulator which
complies with SANS 1237 must be used.
Permanent installation
Important information for the user
This appliance may only be installed by a
registered LP Gas installer. All registered
installers are issued with a card carrying
their registration number.
Ask to be shown this card before
allowing the installation to commence
and make a note of the installer QCC
number on page 24 of this book.
Upon completion of the installation, the
installer is required to explain the operational
details of the appliance together with the
safety instructions. You will be asked to sign
acceptance of the installation and be
provided with a completion certificate. You
should only sign for acceptance when the
installation is completed to your satisfaction.
Failure to comply with the above will
render the warranty invalid.
Note:
Your invoice is required in the event of
you wishing to make a warranty claim.
To Next Page
Loading...
