PAGE 16 OF 22
CLEANING AND CARE
INSIDE THE OVEN
Turn off the oven and remove the power plug from the wall socket before cleaning. Keep the inside
of the oven clean. For easy cleaning, wipe spills and spatters as they occur with a damp cloth or sponge
with water and a mild detergent. Avoid the use of aerosols and other harsh cleaners as these may stain,
streak or dull the door surface. Rinse the cavity of any cleaning residue with a clean damp or sponge after
cleaning. Dry with a soft cloth. These areas can also cleaned by using plastic or nylon scouring pads. For
hard to remove soil, use a mild non-abrasive cleaner. Use on the stainless steel areas, turntable and
rotating base only. Remove odours from your oven by combining a cup of water with the juice and the skin
of one lemon in a deep microwave proof bowl, microwave for 5 minutes. Wipe thoroughly and dry with a
soft cloth.
Warning
Just as your traditional oven becomes hot also this oven will become hot during use of the functions.
Children should be supervised at all times when using the oven.
TURNTABLE AND ROTATING BASE
These two parts are easily removable for cleaning. The turntable should be cleaned frequently. If food
spills are accumulated under the rotating base, the oven will not operate efficiently. Be sure to wipe up any
spills as they occur in this area. Clean these parts as described in cleaning inside of the oven. Be sure to
properly reinstall these parts into the cavity after cleaning.
When removing the rotating base from cavity floor for cleaning, be sure to replace it correctly.
DOOR
Wipe the door and window (both sides), the door seals and adjacent parts frequently with a damp cloth to
remove any spills or spatters. Do not use any abrasive cleaners.
While the oven door is still warm, any spatters or food soils should be wiped off with a damp sudsy cloth or
sponge. Rinse with water and wipe dry with a cloth. If steam accumulates inside or around the outside of
the oven door, wipe it with a soft cloth. This may occur when the microwave oven is operated under high
humidity conditions and is normal.
EXTERIOR
CONTROL PANEL
Exercise care when cleaning this area. Do not allow the control panel to become wet. Clean. When
cleaning the control panel, leave the oven door open to prevent the oven from accidentally switching on. To
clean, wipe the panel with a slightly dampened cloth, using only water. Wipe dry. Do not scrub this area or
use any sort of chemical cleaner. Avoid use of excess water.
OUTSIDE SURFACE
The outside surfaces should be cleaned with a damp cloth. To prevent damage to the operating parts
inside the oven, water should not be allowed to seep into the ventilation slots.
Although your oven is provided with safety features, it is important to observe the following:
When opened, the door must not be subjected to strain, for example, a child hanging on an opened door or
any load could cause the oven to fall forward to cause injury and also damage to the door. Do not operate
the oven if it is damaged, until it has been repaired by a service technician. It is particularly important that
the oven closes properly and that there is no damage to the:
1) Door (bent)
2) Hinge and latches (broken or loosened)
3) Door seals and sealing surface.
4) The oven should not be adjusted or repaired by anyone except a properly trained service technician.
If it becomes necessary to replace the oven lamp, consult a Defy Service Centre to have it replaced.
Replacement lamps are not covered by the warranty. The oven should be cleaned regularly and any food
deposits removed. Failure to maintain the oven in a clean condition could lead to deterioration of the
surface that could adversely affect the life of the appliance. It could also constitute a fire risk.
Do not dispose this appliance at the local dump. It should be disposed of at a disposal center provided by
the municipality.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
