Defy DTD 297 User Manual

18 - EN
A Never use solvents, cleaning agents or
substances alike when cleaning as these
might cause fire and explosion!
Water tank (Products equipped
with a condenser);
The moisture in the damp laundry is taken
from the laundry and condensed. Drain the
water tank after each drying cycle or during
drying when "Water tank" warning LED comes
on.
A Condensed water is not drinkable!
C Youcanusethewaterinthewatertankin
your steam irons or air humidifiers.
A Never take out the water tank when the
program is running!
Water tank may be located in two different
places as indicated below, depending on the
model of your machine.
- Inside the drawer on the panel
- Inside the kick plate cover
If you forget to drain the water tank, your
machine will stop during the following drying
cycles when the water tank is full and the
"Water tank" warning LED will light on. If this
isthecase,pressthe"Start/Pause/Cancel"
button to resume the drying cycle after
draining the water tank.
In order to drain the water tank;
1 Carefully remove the water tank by
opening the kick plate cover/pulling the
drawer.
3 Drain the water by opening the water tank
cover.
4 If there is lint accumulation in the water
tank cover, clean it and press to close.
5 Placethewatertankintoitsseat.
Cover filter
Lint and fibres released from the laundry to
the air during the drying cycle are collected in
the "Cover Filter".
C Such fibre and lint are generally
formed during wearing and washing.
C Always clean the filter after each
Drying process.
C Youcancleanthefilterandfilterarea
by vacuum cleaner.
For Filter cleaning;
1 Take out the cover
2 Removethecoverfilterbypullingitup
and open the filter.
3 Clean lint, fibre, and cotton raveling by
hand or with a soft piece of cloth.
4 Close the filter and place it back into its
seat.
Sensor (models equipped with
a sensor)
There are humidity sensors in your machine
that detect whether the laundry is dry or not.
For sensor cleaning;
1 Openthecoverofyourmachine.
2 Allow the machine to cool off if drying has
been carried out.
3 Wipe the metal sensors with a soft cloth,
dampened with vinegar and dry them.
C Clean metal sensors 4 times a year.
7 Maintenance and cleaning

Defy DTD 297 Specifications

General

Brand	Defy
Model	DTD 297
Category	Dryer
Language	English