41
Water droplets on record
after drying
Water droplets on the record aer
the drying cycle can be caused by
insuicient drying time, too high
fan power setting, small amounts
of water being le in the ultrason-
ic cleaning tank at the end of the
washing cycle, or by a valve leaking
water back into the ultrasonic
cleaning tank.
Maximum Fan Power setting can
on rare occasions throw up a few
drops of water that has been le
in the ultrasonic cleaning tank. The
drying program will eventually dry
these o, but it can cause trouble
when trying to set precise drying
length.
In order for the machine to pump
out all the water from the ultrasonic
cleaning tank, it is impoant for the
filter to be suiciently clean. With
a clogged filter, some of the water
can get trapped and will seep
through to the ultrasonic cleaning
tank later while the machine is
drying the record.
If the issue persis, then the cause
may also be a clogged valve that
leaks a small amount of water back
into the cleaning tank. To clean the
valves, a the Machine mainte-
nance cycle manually. The main-
tenance program will pump water
back and foh through the valves
and may remove debris uck in
there.
To a Machine maintenance nav-
igate to the Degas program in the
menu. Press and hold the le button
and immediately press the right
button. If this solves the issue, then
clean the machine with vinegar as
described in Cleaning the machine
section.
11 Troubleshooting guide
To Next Page
Loading...