Degritter MARK II - Page 43

43
Clicking sound during
washing
This is normal. During the washing
cycles, the machine monitors the
water level and will make small ad-
juments when necessary. In order
to adju the water level, a valve is
opened and this makes the clicking
sound.
How to empty ultrasonic
tank without power
If the machine has developed a
fault that does not allow it to be
turned on, but there is water le in
the ultrasonic cleaning tank inside
the machine, then removing the
water will be necessary before de-
bugging or shipping the machine.
To remove the water from inside
the cleaning tank, fir detach the
power cable from the machine and
place the Degritter on a waterproof
suace. Remove the filter cap and
the filter housing from the machine.
Face the machine and a very
slowly tilting it to the right, by raising
the le side of the Degritter. Even-
tually the water will a flowing
through the filtration po out from
the machine.
11 Troubleshooting guide
It is also beneficial to remove the
right side panel from the machine
as some of the water may flow over
the ultrasonic cleaning tank and
exit through there.