DekPro PRESTIGE - Level Rail Installation; Step 3 A: Attaching Brackets to Post; Step 3 B: Attaching Brackets to Post

WWW.DEKPROMFG.COM
*Note: Default nished rail height will be 38”
for residenal and 42” for commercial
using standard installaon procedure
with 3-1/8” support block.
DekPro™ Presge Aluminum Rail System
Level Railing Installaon Instrucons
Level Rail Installaon
Step 3a: Aaching Brackets to Post
• Clamp Presge™ Quick Jig to post.
• Insert brackets into the Quick Jig
• Use T30 Torx self-drilling screws to fasten bracket.
- Pre-drill holes if desired
• Remove Quick Jig.
Clamp Quick Jig
Fasten Bracket
*Note: Quick Jig is also used to plumb posts
using the aached 2 way level.
*Note: Default nished rail height will be 38”
for residenal and 42” for commercial
when using Presge™ Quick Jig with
3-1/8” support block.
Standard Installaon - Using Presge Quick Jig
Step 3b: Aaching Brackets to Post
Boom Rail Bracket Installaon:
• Measure up 2-1/2” from the top of the
base plate and mark a horizontal line.
• Center the bracket on the post with the
boom edge of the bracket at the line you
marked previously
• Use T30 Torx self-drilling screws to fasten
bracket. (Pre-drill holes if desired)
Standard Installaon - Without Quick Jig
Boom
Top
35-3/4”
(38” Rail)
2-1/2”
39-3/4”
(42” Rail)
*Note: Installaon for boom bracket is the
same for 38” rail and 42” rail using
the 3-1/8” support block.
Top Rail Bracket Installaon:
• For 38” Rail: Measure up 35-3/4” from the
top of the base plate and mark a horizontal line
• For 42” Rail: Measure up 39-3/4” from the
top of the base plate and mark a horizontal line
• Center the bracket on the post with the
boom edge of the bracket at the line you
marked previously
• Use T30 Torx self-drilling screws to fasten
bracket. (Pre-drill holes if desired)
Measure up 2-1/2”
from top of base plate
Center bracket and
aach to post
Measure up 35-3/4”
from top of base plate
(38” rail example).
Center bracket and
aach to post
Level Rail
Page 3