2. To add the second shelf capacity license, enter the license add command
followed by second license key, separated with a space. For example:
# license add xxxx-xxxx-xxxx-xxxx-xxxx-xxxx-xx
Added "xxxx-xxxx-xxxx-xxxx-xxxx-xxxx-xx" : CAPACITY-ACTIVE feature for 32.7 TiB
capacity DS60
3. Enter the storage add tier active enclosure
enclosure-id
command
for each enclosure that is to be added to a tier. The following output example
displays Enclosure 3:
# storage add tier active enclosure 3
Checking storage requirements...done
Adding enclosure 3:1 to the active tier...Enclosure 3:1 successfully added to the
active tier.
Adding enclosure 3:2 to the active tier...Enclosure 3:2 successfully added to the
active tier.
Enclosure 3:3
**** Could not add storage:
Exceeded licensed capacity limit for active tier.
Need DS60 CAPACITY-ACTIVE license for at least 36TB (32.7TiB) capacity.
Enclosure 3:4
**** Could not add storage:
Exceeded licensed capacity limit for active tier.
Need DS60 CAPACITY-ACTIVE license for at least 36TB (32.7TiB) capacity.
Updating system information...is done
Successfully added: 3:1 3:2 done
And for a Data Domain system with Extended Retention:
# storage add tier archive enclosure enclosure-id
In a single-node Data Domain system, storage devices are added to the active
tier by default. In a DD Extended Retention system, you must specify the active
or archive tier.
Specifying an
enclosure-id
makes all disks in the enclosure available to the tier.
This is the preferred method of adding storage to a Data Domain system. To use
this option, all disks in the enclosure must be in the unknown state.
4. After adding storage, enter the disk show state command to verify the disk
state.
# disk show state
Enclosure Disk
Row(disk-id) 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
-------------- ----------------------------------------------
1 . . .
2 U U U U U U U U U U U U U U U
3 |--------|--------|--------|--------|
| Pack 1 | Pack 2 | Pack 3 | Pack 4 |
E(49-60) |v v v |v v v |U U U |U U U |
D(37-48) |v v v |v v v |U U U |U U U |
C(25-36) |v v v |v v v |U U U |U U U |
B(13-24) |v v v |v v v |U U U |U U U |
A( 1-12) |v v v |v v v |U U U |U U U |
|--------|--------|--------|--------|
4 |--------|--------|--------|--------|
| Pack 1 | Pack 2 | Pack 3 | Pack 4 |
E(49-60) |U U U |U U U |U U U |U U U |
Post-Installation Tasks
Add storage license 93
To Next Page
Loading...
