Dell EMC Data Domain DS60 - Add Enclosure Disks to the Volume

Adding enclosure 3:4 to the active tier...Enclosure 3:4 successfully added to the
active tier.
Updating system information...done
Successfully added: 3:1 3:2 3:3 3:4 done
9. After adding all four licences, enter the disk show state command to verify
the disk state:
# disk show state
Enclosure Disk
Row(disk-id) 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
-------------- ----------------------------------------------
1 . . .
2 U U U U U U U U U U U U U U U
3 |--------|--------|--------|--------|
| Pack 1 | Pack 2 | Pack 3 | Pack 4 |
E(49-60) |v v v |v v v |v v v |v v v |
D(37-48) |v v v |v v v |v v v |v v v |
C(25-36) |v v v |v v v |v v v |v v v |
B(13-24) |v v v |v v v |v v v |v v v |
A( 1-12) |v v v |v v v |v v v |v v v |
|--------|--------|--------|--------|
4 |--------|--------|--------|--------|
| Pack 1 | Pack 2 | Pack 3 | Pack 4 |
E(49-60) |U U U |U U U |U U U |U U U |
D(37-48) |U U U |U U U |U U U |U U U |
C(25-36) |U U U |U U U |U U U |U U U |
B(13-24) |U U U |U U U |U U U |U U U |
A( 1-12) |U U U |U U U |U U U |U U U |
|--------|--------|--------|--------|
-------------- ----------------------------------------------
Legend State Count
------ ------------- -----
. In Use Disks 3
v Available Disks 60
U Unknown Disks 75
------ ------------- -----
Total 138 disks
Note
All newly added disks are in v state.
10. Repeat the above steps to add licenses to other shelves.
Add enclosure disks to the volume
Procedure
1. When prompted, enter your sysadmin password.
2. Enter the storage show all command to display the RAID groups for each
shelf:
# storage show all
Active tier details:
Disk Disks Count Disk Additional
Group Size Information
----------- ------------------------------ ----- -------- -----------
dg1 5.1-5.14 14 3.6 TiB
Post-Installation Tasks
Add enclosure disks to the volume 95