Dell EMC E58S PowerEdge R340 - Drives; Removing a Drive Blank

Figure 22. Installing a fan
Next steps
1. Install the air shroud.
2. Follow the procedure listed in the After working inside your system.
Drives
Removing a drive blank
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. If installed, remove the front bezel.
CAUTION: To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Press the release button, and slide the drive blank out of the drive slot.
Figure 23. Removing a drive blank
Installing and removing system components
27