Dell EMC E58S PowerEdge R340 - Drive Backplane

Figure 60. Installing the M.2 SSD module
Next steps
1. Install the BOSS card.
NOTE: The procedure to install the BOSS card is similar to removing an expansion card.
2. Install the air shroud.
3. Follow the procedure listed in the After working inside your system.
Drive backplane
Drive backplane
Table 10. Supported backplane options for PowerEdge R340 system.
System Supported backplane options
PowerEdge
R340
2.5-inch (x8) SAS/SATA/SSD backplane
3.5-inch (x4) SAS/SATA backplane
Figure 61. 2.5-inch (x8) SAS/SATA/SSD backplane
1.
Release tabs (2) 2. Backplane SAS B0 connector
3. Backplane signal connector 4. Backplane SAS A0 connector
5. Backplane Power A connector
Installing and removing system components 61