Dell EMC E58S PowerEdge R340 User Manual

Figure 31. Removing the intrusion switch
Next steps
1. Replace the intrusion switch.
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
1. Align and insert the intrusion switch in the slot until it is firmly seated in the slot on the chassis.
NOTE: Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
2. Connect the intrusion switch cable to the connector on the system board.
Figure 32. Installing the intrusion switch
Next steps
1. Follow the procedure listed in After working inside your system.
Installing and removing system components
35

Dell EMC E58S PowerEdge R340 Specifications

General

Brand	Dell EMC
Model	E58S PowerEdge R340
Category	Server
Language	English