About this task
The following image indicates the location of the camera/microphone module and provides a visual representation of the
installation procedure.
Steps
1. Align and place the camera/microphone module into the slot on the display back cover.
2. Connect the camera/microphone cable to the connector on the camera/microphone module.
Next steps
1. Install the display hinges.
2. Install the display panel.
3. Install the display bezel.
4. Install the display assembly.
5. Install the battery.
6. Install the base cover.
7. Install the microSD card.
8. Install the SIM card.
9. Follow the procedure in After working inside your computer.
eDP/display cable
Removing the eDP cable
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter service mode.
3. Remove the SIM card.
4. Remove the microSD card.
5. Remove the base cover.
6. Remove the display assembly.
7. Remove the display bezel.
8. Remove the display panel.
Removing and installing components
73
To Next Page
Loading...
