Dell EMC PowerMax Series - PowerMax 2000 line cord and jumper configurations

Three-phase Delta
The following table describes the power cords for three-phase Delta power transmission. Each power cord model contains two (2) 15FT
(4.57M) cords.
PowerMax 2000 systems do not require jumpers for three-phase power. PowerMax 8000 systems use a jumper, PN 038-004-435, for
three-phase Delta. See PowerMax 8000 line cord and jumper configurations on page 41 for line cord and jumper configurations.
The ordering system defaults to one of the power cord models based on the country of installation. The default value can be overridden in
the ordering system.
Table 25. Power cords – Three-phase Delta
Power cord models Power cable part
numbers
Description Dell EMC power cord plug Customer PDU receptacle
PowerMax 2000: EH-
PCBL3DHH
PowerMax 8000: EZ-
PCBL3DHH
038-004-431 (Black)
038-004-432 (Gray)
PWR CBL HBL-HBL
3D
Hubbell CS-8365L Hubbell CS-8364
PowerMax 2000: EH-
PCBL3DHR
PowerMax 8000: EZ-
PCBL3DHR
038-004-433 (Black)
038-004-434 (Gray)
PWR CBL HBL-
RSTOL 3D
Russellstoll 9P54U2 Russellstoll 9C54U2
PowerMax 2000 line cord and jumper
configurations
Three-phase power
For a single PowerMax 2000 system in a rack on three-phase power, a line cord in the P1 outlet energizes PDU outlets 1-18 on circuit
breakers 1-6. If a second system is added to the rack, you must add a line cord in the P2 outlet to energize PDU outlets 19-37 on circuit
breakers 7-12. No jumpers are required for three-phase power.
Table 26. PowerMax 2000 line cord configurations, three-phase
PowerBrick Components Line cord location
PowerBrick 2 (Upper System) DAE 4 No additional line cords required
DAE 3
SPS 2A/2B
PowerBrick 1 (Upper System) DAE 2 P2
DAE 1
SPS 3A/3B
PowerBrick 2 (Lower System) DAE 4 No additional line cords required
DAE 3
SPS 2A/2B
PowerBrick 1 (Lower System) DAE 2 P1
DAE 1
SPS 3A/3B
Power Cabling, Cords and Connectors 39